For the most part, the Allen wrench was just fine. But youll want a drill to screw the panels onto the border of the bed frame.
Instructions are very easy to follow.
Youll definitely need a second person to align the side panel to the top panel. But other than that you can do this by yourself.
Pro tip: when you are finished sliding all of the slats into the black sleeve, and the next step is to screw three metal support beams in the center DO NOT. I repeat DO NOT screw them in tightly. Why? Welp, you have to slide in two other long supporting beams and if that is too tight youll have to go back and loosen them (pain in the $!). You can go back after its put in its place and tighten without a problem.
Other than that easy peasey.
2 person job recommended
For the most part, the Allen wrench was just fine. But youll want a drill to screw the panels onto the border of the bed frame. Instructions are very easy to follow. Youll definitely need a second person to align the side panel to the top panel. But other than that you can do this by yourself. Pro tip: when you are finished sliding all of the slats into the black sleeve, and the next step is to screw three metal support beams in the center DO NOT. I repeat DO NOT screw them in tightly. Why? Welp, you have to slide in two other long supporting beams and if that is too tight youll have to go back and loosen them (pain in the $!). You can go back after its put in its place and tighten without a problem. Other than that easy peasey.