Not the easiest to assemble.. but doable. One part wasnt all too clear, 3 steps later I learned this one bar needed to face outward, not inward..had to disassemble 3 steps then move forward. But at least I got a version where all the holes lined up, phew! I was fearful Id have to go buy tapping screws, as others mentioned. Definitely needs 2 people to assemble. Upon completion and set up, I was moving it just a few inches, making small adjustments and quickly learned you cant do that. Once the printer stand part is attached to the desk part, its very difficult to move the entire thing without snapping or breaking something off. The points where they join (printer stand and desk) are very weak, could have been designed more sturdy there. But Im not planning on throwing a rave on top of it, so I should be good! ;) looking forward to trying it out next week!
Great desk!
Not the easiest to assemble.. but doable. One part wasnt all too clear, 3 steps later I learned this one bar needed to face outward, not inward..had to disassemble 3 steps then move forward. But at least I got a version where all the holes lined up, phew! I was fearful Id have to go buy tapping screws, as others mentioned. Definitely needs 2 people to assemble. Upon completion and set up, I was moving it just a few inches, making small adjustments and quickly learned you cant do that. Once the printer stand part is attached to the desk part, its very difficult to move the entire thing without snapping or breaking something off. The points where they join (printer stand and desk) are very weak, could have been designed more sturdy there. But Im not planning on throwing a rave on top of it, so I should be good! ;) looking forward to trying it out next week!